If
, that indicates the machine is out of order
0 "Error code" ,
please turn off the main power and water supply before calling a service.
program
(page 2 th
)
some of the left four
lights fast blinking
12
NOTE:
A forgotten dish can be added any time before the detergent cup opens.
Open the door a little to stop the washing.
After the spray arms stop working, you can open the door
completely.
Add forgotten dishes.
Close the door
, the
dishwasher will run after 10 seconds.
and press the Start/Pause button
4
3
2
1
The program lights shows the state of the dishwasher:
ll of the program lights off
)some of the left four
lights fast blinking -->error
a) A
--> stand by
b) One of the program lights on --> pause
c) One of the program lights blinking slowly --> run
d
program
Please press the Start/Reset button and last more than
three seconds, this will cancel the current programme;
or turn off the appliance by pressing the on/off button
to cancel the current programme.
Turn around the programme knob to select the desired
programme.
Press the Start/Pause button to start washing.
1
2
3
Premise
: A cycle that is underway can only be modified if it
has only been running for a short time. Otherwise, the detergent
may have already been released, and the appliance may have
already drained the wash water. If this is the case, the detergent
dispenser must be refilled (see the paragraph entitled " Loading
the Detergent " ).
NOTE:
If you open the door when washing, the machine
will pause. When you close the door and press the
Start/Pause button, the machine will keep on working after
10 seconds.
3
4
5
6
7
8
1
Draw out the lower and upper basket, load the dishes and
push them back. It is commended that loading the lower
basket first, then the upper one (see the section entitled
" Loading the Dishwasher " ).
Press the ON/OFF button
Turn the knob located on the right of the control panel in
the clockwise direction until the number or the symbol
for the cycle
Press the Start/Reset button to start the washing.
When the washing is over, you can shut off the switch by
pressing on/off button..
With a little force to ensure the door is properly closed.
NOTE:
A click could be heard when the door is closed
perfectly.
2
Pour in the detergent(see the section entitled,
" Salt, Detergent and Rinse Aid " ).
Insert the plug into the socket.
The power supply is 220-240VAC 50HZ, the specification
of the socket is 10A 250 VAC, Make sure that the water
supply is turned on to full pressure.
It is dangerous to open the door when washing,because the hot water may scald you.
Open the door carefully. Hot steam may escape when the door is opened!
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes.
In this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and than the upper one. This will avoid water dripping from the
upper basket onto the dishes in the lower one.
