10
MODEL: SCF142WE | PRODUCT CODE: 62330 | 10/2018
Getting Started
Unpacking
• Packaging materials:
This appliance has been packaged to protect it against transportation damage.
Remove all packaging materials from around and inside the appliance and keep the original packaging
carton and materials in a safe place. It will help prevent any damage if the product needs to be transported
in the future, and you can use it to store the appliance when it is not in use. In the event the carton is to be
disposed of, please recycle all packaging materials where possible.
• Check:
to see if all items are present.
• Inspect:
the equipment and accessproes for transport damage. In case of complaints, the supplier is to
be informed immediately.
•
Suffocation:
Plastic wrapping can be a suffocation hazard for babies and young children, so ensure all
packaging materials are out of their reach and disposed of safely.
• Power cord:
Unwind the power cord to its full length and inspect it for damage. Do not use the appliance
if it or its cord have been damaged or are not working properly. In case of damage, contact our after sales
support line for advice on examination, repair or return of the damaged product.
• Read the manual:
Read this manual to familiarise yourself with the appliance. Pay particular attention to
the safety instructions on the previous pages.
• Clean:
To remove any dust from transit and storage, clean the interior and exterior surfaces of the
appliance with lukewarm water and a soft cloth. Dry thoroughly.
Important:
do not use harsh or abrasive
detergents or powders as these will damage the finish.
Installation
• Two person installation:
Use two or more people to move and install the appliance. Failure to do so can
result in back or other injury.
• Freestanding design:
This appliance is designed to be freestanding only, and should not be recessed or
built-in.
• Floor surface:
This appliance must be properly positioned on a dry, sturdy, level surface that is strong
enough to support it when it is fully loaded.
• Ambient temperature:
The ambient temperatures must correspond to the climate class (
T
) indicated on
the rating plate of the appliance: 16° C – 43° C.
• Clearances:
Ensure that air can circulate freely around the back of the cabinet, which is necessary to
cool the compressor and condenser. Allow at least 12cm clear space at the back and 5cm at the sides of
the unit.
• Wall Units Above:
Ideally, the appliance should not be positioned below overhanging wall units.
However, if the appliance must be positioned below an overhanging wall unit, make sure to allow sufficient
room so you can comfortably open the lid and access the contents.
Do NOT
install/use the appliance in the following locations/situations:
• In moist areas or areas of high humidity.
• In a recreational vehicle, or for use with an inverter.
• In direct sunlight, near heat sources, next to an open flame, cooking or heating appliance, or near any
other source of high heat.
• Direct sunlight may affect the acrylic coating and heat sources may increase the unit’s power
consumption. For best energy efficiency install the appliance in the coolest area of the room.
• In an area with extreme cold ambient temperatures.
• In an area with excessive moisture and high humidity. Make sure it is protected from elements such as
wind, rain, water spray or drips.
• In an area where petrol or other explosive and/or flammable liquids or fumes are used or stored. The
fumes can create a fire hazard or explosion.
