8
Using a Double DIN Dash Kit:
Radio chassis mounts to the brackets attached to the kit main frame
4A
1
2
1
2
HOOK BOTTOM
FIRST, THEN TOP
#10 X 3/8
Coarse Thread Screw
M5 X 10
AFTERMARKET
DASH KIT
(NOT INCLUDED)
NOTE: BOOT AND DASH KIT NOT SHOWN
FIG. D
FIG. C
Display Adjustment & Mounting:
1. Install the dash kit side brackets to the main frame.
2. Making sure to use all 8 screws, loosely attach the radio module & mounting bracket assembly to the side
kit brackets (
FIG. C
).
a. (4x) #10 X 3/8 screws for the plastic mounting bracket locations
b. (4x) M5 X 10 or (4x) M4 X 10 screws for the radio module locations (use any combination of screws
to locate the radio in the best position)
3. Attach the display to the bracket assembly by
hooking bottom spring hook and then pushing up and
hooking top hooks. (
FIG. D
)
4A
FIG. E
FIG. G
FIG. F
9
4. Determine the desired position of the display:
a. Display can be vertical or tilted up (
FIG. E
)
b. Display can slide up or down (Page 7)
c. Display can be tilted horizontally (Page 7 – FIG. B)
Note:
There are multiple mounting holes on
the mounting bracket to allow adjusting the
mounting depth. You may drill additional holes
in the mounting bracket and/or the dash kit
brackets to align the display in the best position
and ensure you can use all 8 mounting screws.
5. Once in the desired position, tighten screws
to the radio chassis (top) and mounting bracket
assembly (bottom).
Note:
If the display prevents the factory dash
panel(s) from being installed last, do not push
the display all the way up against the dash
kit. Leave enough bottom gap as the display's
bottom edge rotates towards the dash kit.
6. Remove the display from the bracket
assembly by pushing up from compression
spring side (1) and swing out to unhook top (2).
(FIG. F)
Note:
If there is a depth issue with the radio
module in the top position, move it to the
bottom location by inverting the mounting
bracket assembly.
(FIG. G)
VERTICAL TILT:
Use
Hole A
for no vertical
tilt or
Hole B
for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
A
M5 X 10
M5 X 10
Compression Spring
PROCEED TO STEP 5
on Page 16
B