16
If needed, attach the rubber boot to
the display clamp assembly by aligning
the notch on the top edge as shown,
and hook the boot to the clamp at 5
locations.
(FIG. W)
Note:
The boot is not required if display
sits very close to the dash/dash kit and
no large gap is seen.
BOOT ASSEMBLY PLASTIC "TAB"
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
BOOT ASSEMBLY HOOKS
AT 5 SPOTS
(RUBBER BOOT NOT SHOWN)
BOOT ASSEMBLY PLASTIC "TAB"
HAS TO GO INTO A NOTCH
(DISPLAY UNIT NOT SHOWN)
BOOT ASSEMBLY HOOKS
AT 5 SPOTS
(RUBBER BOOT NOT SHOWN)
After all wiring connections are made
in the next section, the dash kit with the
radio chassis and bracket assembly,
should be installed and any factory
panels reinstalled. Connect the 8 Pin
Display Power Harness and the LVDS
Video Cable to the back of the display
and attach display to mounting bracket.
5
6
FIG. W
Wiring and Connections
Final Assembly
17
Display Cable
Multi Camera
USB1 CP/AA
1
Power / Speaker
GPS Antenna
2
LVDS Cable
HDMI Input
USB2
SWI
AV In/Out - Rear Camera
Microphone
SiriusXM Tuner
Radio Antenna
TOSLINK
2
GPS Antenna must be installed for accurate
operation of Apple CarPlay, Android Auto &
internal Navigation.
1
The top USB1 must be used for
Apple CarPlay and Android Auto.
15 Amp Fuse
