6
Chains
Inspect the chains after the first 4 hours of use and adjust as
needed. A properly tensioned chain should have 1/4-3/8”
of slack.
Make sure the chain is clean and free of any debris.
Every month or 50 hours check the chain tension.
Chain Tensioning:
1. Loosen idler sprocket nut as shown in Figure 4 but do
not remove.
2. Slide sprocket up to increase chain tension and
retighten the idler sprocket nut.
3. Lubricate both chains with cycle chain lube weekly
Engine
Run unleaded gasoline with an octane rating of 86 or higher
and 10% or less ethanol.
Check engine oil level on level ground daily
Drain Honda engine’s oil by removing oil plug in figure 5.
Drain Briggs engine’s oil by removing dip stick as shown in
figure 6 and carefully roll the unit onto its side .
Change the oil within the first month or 10 hours, do not
overfill unit.
Regular oil changes are required every 6 months or 50 hours
or sooner depending on conditions.
10w30 is recommended
Clean/replace the air filter every 3 months or 25 hours.
See supplemental Engine manufacturer booklet for
additional maintenance procedures and requirements
Содержание Dual-Aer 2400
