Still STEDS R70-16, Быстрый старт, Страница: 13 / 16

Steering cylinder removal
– Remove track rods.
– Disconnect hydraulic connections after
having marked them for identification.
WARNING : Hydraulic oil may spill when
disconnecting lines; be prepared
for oil spillage!
– Slacken the four fixing screws (1). .
Steering cylinder installation
– Retighten the fixing screws (1).
Torque
loading: M
A
= 210 Nm
– Reconnect hydraulic connections.
CAUTION:
Do not swap hydraulic connections!
– Install track rods.
NOTE: For steering cylinder dismantling and
reassembling refer to F.G. 06.
Lubricating the steer axle with grease
– Operate the linkage during greasing while the
steer axle is off load.
– Using a grease gun, lubricate with FL grade
grease the 8 fittings with which the steer axle
is equipped until a small amount of fresh
grease oozes out at the lubricating points.
NOTE: When lubricating the upper bearing, the
grease need not ooze out of the upper sealing
ring, it may also escape from the bottom.
02
Steer axle
10
Workshop Manual 7052/56/74-76, 7054/58/77-79