Still RX70-40, Оригинальное руководство пользователя

Страница: 204 / 392

4
Operation
Attachments
Load capacity with attachment
The permissible load capacity of the attach-
ment and the allowable load (load capacity
and load moment) of the truck must not be ex-
ceeded by the combination of attachment and
payload. The specifications of the manufac-
turer and supplier of the attachment must be
complied with.
– Observe the residual load capacity rating
plate, see the chapter entitled "Taking up a
load using attachments".
7090_900-001
Releasing the pressure from the
hydraulic system
Prior to assembling attachments, the plug
connectors must be depressurised.
Attachments must only be installed by au-
thorised personnel in accordance with the
information provided by the manufacturer and
supplier of the attachments. After each instal-
lation, the attachment must be checked for
correct function prior to initial commissioning.
NOTE
The pressure release procedure is dependent
on the operating devices for controlling the
hydraulic functions; see the section entitled
"Lifting system operating devices".
NOTE
Before carrying out pressure release, lower
the fork carriage and tilt the lift mast back to
the stop. The key switch must be switched on
to release the pressure from the system, but
do not start the engine.
NOTE
In trucks with the "FleetManager" or "access
authorisation with PIN code" equipment va-
riants, access authorisation must be enabled.
– Switch on the key switch.
– Wait two to three seconds.
192 57348011850 EN - 02/2019 - 11