Still LXT 120, Оригинальное руководство пользователя

Страница: 83 / 324

Switching on via push button
(variant)
WARNING
Automatic brake function test.
When the industrial truck is switched on, the service
brake performs an automatic self test. The brake is
applied without the driver depressing the brake ped-
al.
–
Therefore, the brake system must not be opened
before the truck is switched on, e.g. to bleed it.
WARNING
Before switching on the industrial truck, all checks
and tasks required before daily use must have been
performed without any defects being identified.
–
Perform the visual inspections and function check-
ing.
–
Do not operate the industrial truck if defects have
been detected; contact the authorised service
centre.
The "Switch on via push button" variant is
available only in conjunction with the "Fleet-
Manager" or "Access authorisation with PIN
code" variants. In place of the key switch, the
industrial truck has a push button that is used
to switch it on and off.
–
To switch on the truck, press the push but-
ton (1) or sit on the driver's seat. A mes-
sage on the display-operating unit asks the
operator to place the "FleetManager" card
in position or to enter the PIN code. See the
chapter entitled "Access authorisation with
PIN code" or the "FleetManager" operating
instructions.
Authorisation via the "FleetManager" card or
the PIN code must take place within a speci-
fied period of time:
●
If you are not sitting in the driver's seat,
within 30 seconds.
●
If you are sitting in the driver's seat, within
60 seconds.
If this does not happen, the industrial truck
switches off again.
If authorisation was successful, the industrial
truck is ready for operation. The main screen
is shown on the display.

Operation
4
Switching on
71 50078078001 EN - 07/2022 - 04