Stilevs Utumax UT-8055, Инструкция по эксплуатации

Страница: 11 / 20

11
INSTRUCTIONS MANUAL
Thank you for choosing our products. This instructions manual has been prepared
for you to achieve complete satisfaction and maximum performance from you
product.
I. IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be followed ,
including the following:
To make good use of your appliance , please read these instructions carefully
and look at the illustrations before using it.
• Use the iron only for its intended use.
• To protect against the risk of electric shock, do not immerse the iron in water
or other liquids.
• The iron should always be turned to “min” before plugging or unplugging from
the mains outlet. Never pull the cord to disconnect from the mains: instead,
grasp plug and pull to disconnect.
• Do not allow the cord to touch hot surfaces. Allow the iron to cool completely
before putting away.
• Always disconnect the iron from the electrical outlet when filling with water or
emptying and when not in use
• Do not operate the iron with a damaged cord or if the iron has been dropped
or damaged. To avoid the risk of electric shock, do not disassemble the iron
.take it to a qualified service agent for examination and repair. Incorrect re-
assembly, can cause a risk of electric shock when the iron is used.
• Close supervision is necessary for any appliance being used by or near
children. Do not leave the iron unattended when connected to the mains or
on an ironing board.
• Burns can occur from torching hot metal parts, hot water or steam, use
caution when you turn a steam iron upside down-there may be hot water in
the reservoir.
• If the iron is not operating normally ,disconnect from the power supply. And
contact the nearest authorized service agent.
• Your iron is designed to rest on the heel. Do not leave the iron unattended
when switched on. Do not place the iron on an unprotected surface even if it
is on its heel rest.
• Check that the voltage on the product rating plate coincides with your mains
voltage.
• The iron shall not be used if there are visible signs of damage or if the iron
in leaking .The iron shall be sent to the manufacturer or his qualified service
agent before further use.
• Completely unwind the mains cable.
• Always unplug the iron when not in use ,even if only for a short period of time.
Unplug it from the mains and leave it standing on its rear base.
• Make sure that children can not touch the hot iron and that they can not pull
on the mains wire.