Stihl RMI 522 C, Инструкция по эксплуатации

Страница: 68 / 96

0478 131 8365 C - EN
66
Maintenance operations on days with
active times:
● Visually inspect the general condition of
the machine and the docking station.
● Check the display – check the current
time and the start of the next mowing
operation.
● Check the mowing area and remove
foreign bodies, etc. as required.
● Check that the battery is being charged.
(
Ö 15.7)
Weekly maintenance operations:
● Clean the machine. ( Ö 16.2)
● Visually inspect the mowing blade,
blade fastening and mowing deck for
damage (notches, cracks, fractures,
etc.) and wear. (
Ö 16.3)
Every 200 hours:
● Replace the mowing blade. ( Ö 16.3)
Annual maintenance operations:
● STIHL recommends an annual
inspection by a STIHL specialist dealer
during the winter months.
Here, maintenance of the battery,
electronics and software in particular is
performed.
16.2 Cleaning the machine
Treating the machine carefully will protect
it against damage and extend its service
life.
Cleaning and maintenance position:
Place the machine on a firm, level and flat
surface for cleaning the
top of the
machine (hood, flap). To clean the
underside of the machine (mowing
blade, mowing deck), tilt the robotic mower
onto its left or right side as illustrated and
lean it against a wall.
● Clean off dirt with a brush or a cloth. In
particular, clean the mower blade, the
charging contacts of the robotic mower
and the docking station.
● Remove accumulated clipping deposits
in the housing and in the mowing deck
beforehand using a stick.
● If necessary, use a special cleaner
(e.g. STIHL special cleaner).
● Regularly remove the carrier plate and
remove grass residues. (
Ö 16.6)
16.3 Checking the mowing blade wear
limits
● Activate the disabling device. ( Ö 5.2)
● Tilt the robotic mower onto its side and
lean it securely against a stable wall.
Carefully clean the mowing deck and
mowing blade. (
Ö 16.2)
In order for your specialist dealer to
perform all the maintenance
operations correctly, set the safety
level to "None" or give your
specialist dealer the appropriate
PIN code.
Make sure that the rotary knob is
properly installed before cleaning
as otherwise water can get into the
machine.
The carrier plate must be cleaned
frequently in wet weather. Dirt
deposits between the carrier plate
and the mowing deck housing
create friction, leading to increased
power consumption.
Risk of injury!
A worn mowing blade may break off
and cause serious injuries. The
instructions for blade maintenance
must therefore always be observed.
Mowing blades are subject to
differing degrees of wear
depending on the location and
duration of use. If you use the
machine on sandy ground or use it
frequently under dry conditions, the
mowing blade will be subjected to
greater loads and will wear more
quickly than normal.
Replace the mowing blade at least
every 200 operating hours – do not
resharpen. (
Ö
16.5)