Stihl MSE 220 C, Инструкция по эксплуатации

Страница: 25 / 40

MSE 220 C
English
23
N
Take out the screw (1).
N
Remove the cup springs (2),
washers (3) and sprocket (4).
N
Install the new chain sprocket in the
reverse sequence.
NOTICE
Always mount the chain sprocker with a
new screw (1).
Cutting effortlessly with a correctly
sharpened chain
A properly sharpened chain slices
through wood effortlessly and requires
very little feed pressure.
Working with a dull or damaged chain
requires more physical effort, exposes
the user to higher vibration levels,
produces unsatisfactory cutting results
and increases wear.
N
Clean the chain.
N
Check the chain for cracks in the
links and damaged rivets.
N
Replace any damaged or worn
parts of the chain and match the
new parts to the shape and size of
the original parts.
Carbide-tipped saw chains (Duro) are
particularly wear resistant. STIHL
recommends you have your chain
resharpened by a STIHL servicing
dealer.
WARNING
It is absolutely essential to comply with
the angles and dimensions specified
below. If the saw chain is incorrectly
sharpened – and in particular if the depth
gauge is set too low – there is a risk of
increased kickback of the saw, with
resulting risk of injury.
Chain pitch
The chain pitch (a) is marked on the
depth gauge end of each cutter.
Select file diameter according to chain
pitch – see table “Sharpening Tools”.
You must observe certain angles when
resharpening the chain cutter.
Filing and side plate angles
A Filing angle
1
2
3
4
3
107BA012 KN
Maintaining and Sharpening
the Saw Chain
Mark (a) Chain pitch
inch
mm
7 1/4 P 6.35
1 or 1/4 1/4 6.35
6, P or PM 3/8 P 9.32
2 or 325 0,325 8.25
3 or 3/8 3/8 9.32
689BA027 KN
a
A
B
689BA021 KN