Stihl MSE 220 C, Инструкция по эксплуатации

Страница: 24 / 40

MSE 220 C
English
22
Cooling air flows to the motor through
the slots in the front handle.
N
Use a dry brush or similar tool to
clean the cooling slots at regular
intervals – see "Maintenance
Chart".
N
Take out the screws (1).
N
Remove the screen (2) and
filter (3).
N
Wash the filter in a fresh, non-
flammable solution (e.g. warm
soapy water) and dry thoroughly.
N
Refit the filter and screen.
WARNING
To avoid the risk of electric shock, do not
install the filter while it is still damp.
For periods of 3 months or longer
N
Disconnect the plug from the wall
outlet.
N
Remove the saw chain and guide
bar, clean them and spray with
corrosion inhibiting oil.
N
Thoroughly clean the machine,
especially the cooling air inlets.
N
If you use a biological chain and bar
lubricant, e.g. STIHL BioPlus,
completely fill the chain oil tank.
N
Store the machine in a dry and
secure location – out of the reach of
children and other unauthorized
persons.
N
Disconnect the plug from the wall
outlet.
N
Remove the chain sprocket cover,
chain and guide bar.
N
Engage the chain brake to lock the
chain sprocket – see "Chain Brake".
Replace the chain sprocket
–
after using two saw chains or
sooner
–
if the wear marks (a) on the sprocket
are deeper than approx. 0.5 mm
since this would reduce the life of
the chain. You can use a gauge
(special accessory) to check the
depth of the wear marks.
It is best to use two saw chains in
rotation with one sprocket.
STIHL recommends the use of original
STIHL sprockets to ensure correct
operation of the chain brake.
Motor Cooling
1
2
3
107BA013 KN
1
Storing the Machine Checking and Replacing the
Chain Sprocket
a
000BA054 KN