Stihl MSE 220 C, Инструкция по эксплуатации

Страница: 23 / 40

MSE 220 C
English
21
After finishing work
N
Disconnect the plug from the wall
outlet.
N
Slacken off the chain if you have
retensioned it at operating
temperature during cutting work.
NOTICE
Always slacken off the chain after
finishing work. The chain contracts as it
cools down. If it is not slackened off, it
can damage the drive shaft and
bearings.
Storing for a long period
See chapter on "Storing the Machine"
N
Flip the bar – after each sharpening
and each time the chain is changed
– to avoid uneven wear, especially
at the sprocket nose and on the
bottom
N
Periodically clean the oil inlet
hole (1), oil outlet channel (2) and
bar groove (3)
N
Measure groove depth – using the
measuring tool on the file gauge
(special accessory) – in the area
with the greatest wear
If the groove is not at least this deep:
N
Replace guide bar
Otherwise the drive links will grind
against the base of the groove – the
bottoms of the cutters and the tie straps
will not lie against the bar.
Taking Care of the Guide Bar
2
3
1
143BA026 KN
Chain type Chain pitch Minimum
groove depth
Picco 1/4“ P 4.0 mm
Rapid 1/4“ 4.0 mm
Picco 3/8“ P 5.0 mm
Rapid 3/8“; 0.325“ 6.0 mm
Rapid 0.404“ 7.0 mm