Stihl MS 880, Руководство пользователя

Страница: 9 / 21

8 MS 780, MS 880
Fastener Thread size For component Torque
Nm Remarks
Screw M 6x40 Annular buffer, left top/retainer/tank housing 7.0 1), 4)
Screw P 6x19 Annular buffer, bottom/tank housing 5.5
Screw M 5x12 Annular buffer plate, left top/crankcase 9.0 1), 4)
Screw M 4x12 Rewind spring, fan housing 4.0 4)
Screw M 5 Muffler/collar stud with spring washer (MS
780/new MS 880) 10.0
Screw M 5x16 Muffler/cylinder (MS 780/new MS 880) 10.0 1), 4), 5)
Screw M 5x6 Muffler casing, top (MS 780/new MS 880) 6.5 1), 4)
Crankshaft M 10x1 Flywheel/crankshaft 45.0 6)
Screw M 4x12 Segment/fan housing 2.0 4)
Screw M 4x8 Side plate/crankcase 3.0 4)
Screw M 3x20 Clamp/manifold (MS 780/new MS 880) 0.5
Stud M 5x8.5 Stud/cylinder 3.5 3)
Screw M 5x16 Support/crankcase (old MS 880) 10.0 4)
Screw M 5x16 Support/muffler (old MS 880) 10.0 4)
Screw P 4x19 Tank housing/handle molding 1.0
Spark plug M 14x1.25 Spark plug 25.0
Screw M 5x25 Ignition module/crankcase (old MS 880) 9.0 1), 4)
Screw M 5x20 Ignition module/crankcase 8.0 5)
Screw M 6x30 Cylinder/crankcase 15.0 4)
Remarks:
1) Loctite 242 or 243, medium strength
2) Loctite 649, high strength
3) Loctite 270, high strength
4) Screws with binding head
5) Micro-encapsulated screws
6) Degrease joint and mount oil-free
7) Use Hylomar HYL sealant
Use the following procedure when refitting a DG or P screw in an existing thread:
Place the screw in the hole and rotate it counterclockwise until it drops down slightly.
Tighten the screw clockwise to the specified torque.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread
and weaken the assembly.
Coat micro-encapsulated screws with medium strength Loctite 242 or 243 before reinstalling.
Power screwdriver setting for polymer: DG and P screws max. 500 rpm
Do not use an impact wrench for releasing or tightening screws.
Do not mix up screws with and without binding heads.