Stihl MS 441 C-MQ Magnum, Инструкция по эксплуатации

Страница: 30 / 128

MS 441 C-MQ
English
28
N
Fit the guide bar over the studs (1) –
the cutting edges on the top of the
bar must point to the right.
N
Engage the peg of the tensioner
slide in the locating hole (2) – place
the chain over the sprocket (3) at
the same time.
N
Press down the throttle trigger
lockout in order to disengage the
chain brake.
N
Turn the tensioning
screw (4)clockwise until there is
very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
N
Refit the sprocket cover and screw
on the nuts only fingertight.
N
Go to chapter on "Tensioning the
Saw Chain"
Retensioning during cutting work:
N
Shut off the engine.
N
Loosen the nuts.
N
Hold the bar nose up.
N
Use a screwdriver to turn the
tensioning screw (1) clockwise until
the chain fits snugly against the
underside of the bar.
N
While still holding the bar nose up,
tighten down the nuts firmly.
N
Go to "Checking Chain Tension".
A new chain has to be retensioned more
often than one that has been in use for
some time.
N
Check chain tension frequently –
see chapter on "Operating
Instructions".
N
Shut off the engine.
N
Wear work gloves to protect your
hands.
N
Press down the trigger lockout to
disengage the Quickstop Plus chain
brake.
N
The chain must fit snugly against
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand when the
chain brake is released.
N
If necessary, retension the chain.
A new chain has to be retensioned more
often than one that has been in use for
some time.
N
Check chain tension frequently –
see chapter on "Operating
Instructions".
3
1
1
2 4
001BA187 KN
Tensioning the Chain
1
133BA024 KN
Checking Chain Tension
143BA007 KN