59
MS 271 C, MS 291 C
8.4
ErgoStart
The spring may still be under
tension and must always be
relieved before assembling.
– Pull out the starter rope until the
engine turns – this relieves spring
tension.
– Remove the fan housing and, if
necessary, the segment,
b
8.2
:
Remove the circlip (1).
:
Remove the the washer (2) and
carrier (3).
:
Pull off the spring housing (4).
:
Remove the E-clips (arrows).
:
Pull off the pawls (1) and remove
the torsion springs.
– Clean the seats of the pawls (1),
2710RA330 TG
3
2 1
4
2710RA165 TG
1
1
Installing
:
Fit the torsion springs on the
pawls (1) – note installed position
(arrows).
:
Fit the pawls (1) on the pins (2)
on the flywheel, preload the
torsion springs at the same time
and locate them against the ribs
(arrow).
:
Fit the pawls (1) so that they can
move towards the center of the
flywheel as far as stop (arrow).
:
Fit the E-clips (2).
533RA198 TG
1
1
5902RA581 TG
2
1
2710RA274 TG
2
1
Check operation.
Pawls must move freely and be held
against the stop by the torsion
springs.
:
Push the spring housing (1) over
the starter post and into the
pawls (2) – the pawls must
engage the spring housing.
:
Push the carrier (1) into the
spring housing so that its lug
(arrow) engages the loop (2) of
the rewind spring.
:
Fit the washer (3).
:
Fit the E-clip (4).
– Do not overstretch the retaining
ring.
– Reassemble all other parts in the
reverse sequence.
2
5902RA206 TG
1
5902RA207 TG
2
1
3 4
Содержание MS 271
Страница 1: ...STIH STIHL MS 271 291 2010 06...
Страница 110: ...englisch english 0455 574 0123 M1 15 B11 FST Printed in Germany...