51
MS 260
English / USA
Replacing the starter rope
:
Remove the screws
(1)
.
:
Push the hand guard up.
:
Pull underside of fan housing away
from crankcase and remove it
downward.
:
Ease the spring clip (2) off the
starter post.
:
Carefully remove the rope rotor with
washer
(3)
and pawl
(4)
.
The rewind spring may pop out and
uncoil during this operation.
:
Ease the cap
(5)
out of the starter
grip.
:
Remove remaining rope from the
rotor and grip – make sure the
sleeve is not pushed out of the grip.
:
Tie a simple overhand knot in the
new rope (see “Specifications”) and
then thread it through the top of the
grip and the rope bush
(6)
.
:
Refit the cap in the grip.
:
Thread the rope through the rotor
and secure it with a simple
overhand knot.
:
Coat rope rotor bearing bore with
non-resinous oil.
:
Push the rotor on to the starter post
and turn it back and forth to engage
the rewind spring’s anchor loop.
:
Fit the pawl
(1)
in the rotor.
:
Fit the washer
(2)
on the starter
post.
:
Use a screwdriver or suitable pliers
to install spring clip
(3)
on the starter
post and engage it on the pawl's peg
– the spring clip must point
clockwise – see illustration.
Replacing Starter Rope
and Rewind Spring
1
1
1
1
133BA014 KN
2
3
4
133BA015 KN
133BA040 KN
6
5
133BA017 KN
2
1
3
Содержание MS 260
Страница 69: ...68 English USA MS 260 ...
Страница 137: ...136 español EE UU MS 260 ...