14
English
HTE 60
:
Fit guide bar over the stud (
3
).
Engage peg of tensioner slide in
locating hole (
4
) – place the chain
over sprocket (
5
) at the same time.
:
Now turn tensioning screw (
1
)
clockwise until there is very little
chain sag on the underside of the
bar – and the drive link tangs are
located in the bar groove.
:
Refit the sprocket cover and screw
on the nut only fingertight.
:
Now refer to "Tensioning the Saw
Chain".
The gearbox becomes hot during
operation. To avoid the risk of burn
injuries, do not touch the gear
housing.
Retensioning during cutting work:
:
Switch off the motor and disconnect
plug from power supply.
:
Loosen the nut.
:
Hold the bar nose up.
:
Use screwdriver to turn the
tensioning screw
(
1
) clockwise until
chain fits snugly against the
underside of the bar.
:
While still holding bar nose up,
tighten down the nut
firmly
.
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently – see
chapter on "Operating Instructions /
During Operation".
:
Check chain tension.
The gearbox becomes hot during
operation. To avoid the risk of burn
injuries, do not touch the gear
housing.
:
Switch off the motor and disconnect
plug from power supply.
:
Wear work gloves to protect your
hands.
:
The chain must fit snugly against
the underside of the bar and it must
still be possible to pull the chain
along the bar by hand.
:
If necessary, retension the chain.
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently – see
chapter on "Operating Instructions /
During Operation".
1
5
390BA044 KN
4
3
Tensioning the Saw Chain
1
390BA045 KN
Checking Chain Tension
390BA046 KN
Содержание HTE 60
Страница 31: ...31 HTE 60 English...
Страница 32: ...32 English HTE 60...