Stihl GHE 150, Инструкция по эксплуатации

Страница: 40 / 562

0478 201 9913 B - EN
38
4.9 Disposal
Waste products can be harmful to people,
animals and the environment. They must
consequently be disposed of properly.
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products. STIHL
recommends STIHL specialist dealers.
Ensure that old machines are properly
disposed of. Render the machine
unusable prior to disposal. In order to
prevent accidents, always remove the
power cable and electric cable to the
motor.
7.1 Attaching wheel axle and
wheels
● Attach the wheel axle (C) with
wheel locks (D), bolts (E) and hexagon
nuts (F) to the wheel carrier (B) and
tighten using combination spanner (V)
(
4 - 6 Nm ).
● Push wheels (I) onto mounted wheel
axle.
5. Description of symbols
Caution!
Read the instruction man-
ual before initial use.
Risk of injury!
Keep other persons out of
the danger area.
Risk of injury!
Rotating tools.
Keep hands and feet away
from apertures when
machine is running.
Risk of injury!
Switch off the motor and dis-
connect the power cable
from the machine before
working on the cutting tool,
before performing mainte-
nance and cleaning work,
before checking whether the
electric cable is entwined or
damaged and before leaving
the machine unattended.
Wear hearing protection.
Wear safety glasses.
Wear work gloves.
Risk of injury:
Do not climb onto the
machine.
Risk of injury:
Never put your hands or any
other part of your body or
clothing into the feed chute
or ejection chute.
6. Standard equipment
Item Designation Qty.
A Basic unit with lower chute 1
B Wheel carrier 1
C Wheel axle 1
D Wheel lock 2
E Screw, M6 x 55 2
F Hexagon nut 2
2
H Quick fastener 2
I Wheel 2
J Wheel cap 2
K Square nut 2
L Washer Ø 17 mm 4
M Bolt, M6 x 50 2
N Discharge flap 1
O Ejection chute extension 1
P Strip 1
Q Pin 2
R Torx screw P5 x 20 3
S Upper chute 1
T Safety screw 4
U Torx screw P5 x 10 2
V Combination spanner 1
x
Instruction manual 1
7. Preparing the machine for
operation
Quick fasteners must be pushed
onto the wheel axle only to the
extent that the wheels can still turn
freely.
Quick fasteners are not reuseable
following removal.
Item Designation Qty.
3