Technical Information 40.2010
Page 29
TI_40_2010_13_01_02.fm
.
Insert black lead (
4
) (throttle cable) in the guide
– connector tag and terminal socket on the black
lead are welded and cannot be separated
.
Fasten cable lugs and cable holder (
1
) to the
clutch housing with screw (
5
)
.
Insert blue lead (
6
) (throttle cable) in the guide –
crimped side of the cable lug facing down
.
Insert red lead (
7
) (switch gear) in the guide –
crimped side of the cable lug facing down
.
Insert red lead (
8
) (control unit) in the guide –
crimped side of the cable lug facing down
.
Insert blue lead (
9
) (control unit) in the guide –
crimped side of the cable lug facing down
.
Tighten screws (
10
)
9.9
Service work on carburetor
Position of the special bolt (
1
) must not be changed,
because otherwise the factory default setting will no
longer be correct and this can lead to impaired
engine performance.
Solenoid valve (
2
) must not be dismantled.
9.10
Setting the flywheel air gap
Set the air gap between the arms of the control unit
and the pair of magnetic poles marked "N"/ "S" on
the flywheel – use setting gauge 0000 890 6400
(see
b
7.1)
Air gap: 0.30 mm (+0.05 mm/-0.10 mm)
7
1
4
5903TI025 KN
6
5
10
9
8
5903TI026 KN
2
1
5903TI027 KN
5903TI028 KN