Stihl FS 400, Инструкция по эксплуатации

Страница: 20 / 48

FS 400, FS 450
English
18
Placing power tool on the ground
N
Shut off the engine.
N
Lay your power tool on its back so
that the cutting attachment
mounting face is pointing up.
Mounting Hardware
The mounting hardware supplied
depends on the cutting attachment that
comes as original equipment with the
new machine.
The mounting hardware is fitted to the
gearbox for transportation and must be
removed before mounting a cutting
attachment.
Removing the Mounting Hardware
N
Block the shaft.
N
Use the combination wrench (1) to
loosen and remove the nut (2)
clockwise.
N
Remove the rider plate (3) and
thrust washer (4) (where fitted).
Checking the Thrust Plate
The thrust plate is necessary for
mounting all cutting attachments to the
gearbox.
The thrust plate consists of the thrust
plate body (1) to which a captive guard
washer (2) is fitted.
WARNING
Never use a thrust plate without the
guard washer. Always replace a thrust
plate if the guard washer is missing.
Mounting the Guard Ring
Always fit the guard ring that matches
the cutting attachment you intend to use.
The following guard rings are either
fitted to the gearbox or are available as
special accessories.
Mounting the Cutting
Attachment
002BA406 KN
002BA295 KN
1
2
3
4
1
2
1
681BA196 KN
2