► Rotate the metal cutting attachment (4) coun‐
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
6.6.2
Removing the metal cutting attach‐
ment
► Shut off the engine.
► Insert the stop pin in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment clockwise
until the stop pin engages in position.
The shaft is now blocked.
► Unscrew the mounting nut clockwise.
► Remove the fastening parts, metal cutting tool
and pressure plate.
► Remove the stop pin.
7
Adjusting Trimmer for User
7.1
Fitting and Adjusting the Carry‐
ing System
1
3
2
2
0000-GXX-4594-A0
► Put on the shoulder strap (1) or full harness
(3).
► Adjust the shoulder strap (1) or full harness (3)
so that the carabiner (2) is about a hand’s
width below your right hip.
7.2
Adjusting the Bike Handle
The bike handle can be set to different positions
to suit the height and reach of the user.
► Shut off the engine.
► Hook the brushcutter from the carrying ring
into the carabiner of the carrying system.
2
1
0000-GXX-7849-A0
► Undo the screws (1).
► Swing the bike handle (2) to the required posi‐
tion.
► Tighten down the screws (1) firmly.
7.3
Balancing the Trimmer
The unit is balanced differently depending on the
cutting attachment used.
If a mowing head, grass cutting blade or brush
knife is fitted:
0000-GXX-7836-A0
The cutting attachment should rest lightly on the
ground.
If a circular saw blade is fitted:
0000-GXX-7808-A0
The saw blade must hover at a height of about
20 cm above the ground.
► Shut off the engine.
7 Adjusting Trimmer for User
English
0458-507-0121-B
13
