Stihl FG 3, Инструкция по эксплуатации

Страница: 20 / 72

FG 3
English
18
Sharpening the first row of cutters
N
Sharpen all cutters in this row of
cutters using the setting made with
the master cutter
N
Swivel filing frame upward
N
Advance saw chain to the next
cutter in this row of cutters – press
cutter against stop
Make certain that the stop (3) always
lies precisely against the back of the
cutter that is to be sharpened.
N
Swivel filing frame downward
N
Sharpen cutter
N
Repeat operation until all cutters in
a row of cutters have been
sharpened
Sharpening the second row of cutters
Once all cutters in the first row of cutters
have been sharpened, the sharpening
tool must be set up for the other row of
cutters. Adjustments are made as
described in "Adjustment".
N
Swivel filing frame upward
N
Loosen the knurled nut (1)
N
Lift the guide piece completely out
of the toothing – turn to the identical
angle marking on the opposite side
N
Tighten knurled nut
N
Re-clamp guide bar, rotated by
180°, in a vise or in a STIHL bar
clamp (special accessory)
N
Re-clamp file
N
Swivel filing frame downward
N
Move the round file downward
between the tooth face and depth
gauge of the first cutter in the
second row of cutters
N
Sharpen the first cutter in the
second row of cutters
N
Measure tooth length (A)
If the tooth length varies from the length
of the master cutter:
N
Move stop (3) forward or backward
and sharpen again
N
Check tooth length (A)
N
If necessary, repeat until there is no
longer any deviation
N
Sharpen all cutters in the second
row of cutter using this setting
Depth gauge
N
Select the appropriate file
gauge(special accessory) for the
chain pitch
3
566BA013 KN
1
566BA022 KN
566BA023 KN
566BA024 KN
A
566BA025 KN
3