16
English / USA
FC 100
:
Fit the loop handle
(1)
on the drive
tube 8" / 20 cm
(A)
forward of the
control handle
(2).
:
Position the clamp
(3)
against the
drive tube and slide it into the loop
handle.
:
Fit square nut
(4)
in the loop handle,
insert the clamp screw
(5)
from the
other side and tighten down
securely.
Adjusting loop handle to most
comfortable position:
:
Release clamp screw
(5)
.
:
Move the loop handle along the
drive tube as required - retighten the
clamp screw.
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled
:
Use a suitable tool to push the slide
to the bottom of the slot
Mounting the Loop Handle
3
355BA030 KN
1
2
A
343BA023 KN
5
4
50 mm
( 2" )
Adjusting the Throttle Cable
002BA163 KN
