EN - 11
Tools Required
•
Adjustable wrenches
•
Petroleum jelly or dielectric grease
Unpack Unit
1. Remove unit and all other components
from the shipping container.
2. Engage transmission bypass lever. See
Moving Unit Manually
on page 18.
3. Push unit from container onto a level
surface.
4. Disengage transmission bypass lever.
5. Cut all packaging cable ties on unit and
discard.
6. Remove packaging material from unit
and discard.
Connect Battery
See
Install Factory-Installed Battery
on
page 25 and perform steps 4 and 6 in the
installation section.
Place Unit in Operating Position
(Figure 2)
NOTE:
The unit is shipped with the seat
positioned as far forward as possible and in
service position.
1. Remove steering lever hardware from
bottom hole of the steering lever.
2. Rotate steering lever forward to align
bottom hole with hole in pivot arm and
reinstall hardware.
NOTE:
Do not tighten hardware before
reviewing
Adjusting Steering Levers
on
page 27. If no adjustment is desired, tighten
hardware.
3. Cut all packaging cable ties on unit and
discard.
4. Push steering levers aside and tip seat
into operating position
.
5. Adjust the seat as needed. See
Seat
Adjustment
on page 15.
Check Engine Oil Level
Refer to Engine Manual.
Check Tyre Pressure
See Specifications on page 32.
ASSEMBLY
WARNING:
AVOID INJURY.
Read and understand the entire
Safety
section before
proceeding.
CAUTION:
Avoid injury!
Explosive separation of tyre and
rim parts is possible when they
are serviced incorrectly:
• Do not attempt to put a tyre on
the rim without the proper
equipment and experience to
perform the job.
• Do not inflate the tyres above
the recommended pressure.
• Do not stand in front or over
the tyre assembly when
inflating. Use a clip-on chuck
and extension hose long
enough to allow you to stand to
one side.
Figure 2
1. Steering Lever
2. Steering Lever Hardware
3. Steering Pivot Arm
1
2
3
Содержание ZERO TURN MOWER 915333
Страница 2: ......
