WORKSHOP MANUAL
TC 108 SD -
TC 118 SD
Slacken off the nuts (8) and locknut (9) of the two front
connecting rods (10) and adjust nuts (8) of the front
left con necting rod to set the exact distance «A» of:
– 489 mm (mod. 108)
– 474 mm (mod. 118)
between the centre of the engine pulley hub and the
centre of the left blade shaft.
Measure height “B” obtained on the left connecting
rod after the adjusting and adjust the front tight con-
necting rod nuts until it is the same measurement.
Fully tighten the nuts (8) and lock nuts (9) on both the
front connecting rods.
NOTE
It is very important to ensure that measure
ment “B” is the same on the left side and right side to
guarantee even lifting of the cutting deck.
Turn both the rear screws (5) until the rear of the deck
begins to rise both at the right and the left, and then
tigh ten the relevant locknuts (6).
Push the two connecting rods (7) to the back and
screw down the two nuts (3) on each rod until the front
part of the deck just begins to rise both at the right and
the left, and then tighten the relevant locknuts (4).
Put the machine onto a flat and stable surface (such
as a work bench) and put blocks beneath the cutting
deck in line with the centre lines of the blades:
– at the front 26 mm (1)
– at the rear 32 mm (2)
Set the lifting lever to position «1»-
Slacken off the nuts (3), screws (5) and locknuts (4
- 6) on both the right and left hand sides, so that the
deck rests firmly on the blocks.
CHAPTER
REVISION
FROM ...
PAGE
4.5
0
2018
2 of 2
ALIGNING THE CUTTING DECK