5
7.
Screw U-support tube (#21) to Strut Tubes (#17) with
two Screws (#33) as shown in figure 5. Align holes in
U-support with holes in Strut Tubes and thread screw
(#33) into hole in Strut Tube (#17) Tighten screws all
the way but be careful not to over tighten. You could
strip threads on screws if you over tighten.
8.
CAUTION: Hinges must be positioned exactly
as shown or table will not operate correctly and
could be damaged.
Attach Hinges (#18) to Strut Tubes (#17) as shown in
figure 5. With hinge positioned as shown, align hole in
hinge with hole in Strut Tube and attach with ¼” Screw
(#30), Plastic Washer (#38) and Locknut (#34).
(#38) goes between Strut Tube and
Hinge. Tighten nut securely. Repeat for other Hinge.
Plastic Washer
11. With at least two adults
, repeat steps 6
through 10 for other table top assembly.
.
9.
Attach Linkages (#16) to Leg (#19) as shown in
figure 5. Pivot one Linkage (#16) up and pivot Leg
out from top and align hole in Linkage with hole in
Leg (#19). Attach Linkage (#16) to Leg (#19)
using Hex Head Bolt (#29), Spacer (#37) and
Locknut (#34). Spacer (#37) goes between
Linkage and Leg. Attach other Linkage to Leg the
same way. Tighten nuts securely.
29
16
16
18
Hinge Assembly
18
Hinge Assembly
34
37
34
21
33
17
17
38
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)
40
Spacer goes between
Linkage Arm (#16) and
Leg (#19)
37
16
19
29
33
Figure 5
CAUTION: Hinges must be positioned
exactly as shown or table will not operate
correctly and could be damaged.
10.
Be sure that tabs are aligned with
holes before pushing
Attach Corner Protector (#40) to table corners.
Push snap tabs on Corner Protector into holes in
rails.
. You could break tabs if
they are not aligned correctly.
34
38
30
18
17
30
38
34
30
18
17
Detail A
DO NOT OPEN THE TABLE TO PLAYING POSITION UNTIL
BOTH TOPS ARE INSTALLED! DO NOT LEAVE TABLE
STANDING UNATTENDED. IT COULD BE KNOCKED OVER
CAUSING SERIOUS BODILY INJURY OR PROPERTY DAMAGE.
ATTENTION: If hinge is positioned as
shown below (Detail A), flip the hinge as
shown in Detail B.
Detail B
Incorrect position
of hinge
Correct position
of hinge
