4
10.
Attach end of linkages #4 with two holes to
INSIDE
of U-leg #2 as
shown in Figure 6. Secure through end hole with screws #23, locknuts
#15 and plastic spacers #31. Tighten hardware snug enough to keep
table stable but do not overtighten. Tubes must pivot freely.
11.
On one side of the table attach slotted end of safety strap #6 to
INSIDE
of U-Leg #2 using one bolt #29, one spacer #30, one washer #24,
and one hex nut #15. Tighten hardware until snug but do not overtighten.
Tubes must pivot freely. See Figure 7.
12.
Attach other end of safety strap #6 to
OUTSIDE
of linkage #4 using
one bolt #9, one washer #24, one spacer #30, and one hex nut #15.
Important! Do NOT put other safety strap #6 on this table half. It will
be installed on other table half later.
13.
Attach other end of linkages #4 to
OUTSIDE
of U-support #7 with
bolts #14 and plastic washers #24. Then slide name panel #5 onto
the same bolts #14 on the
INSIDE
of U-support #7. Secure with lock
nuts #15. Tighten hardware until snug but do not overtighten. Tubes
must pivot freely
.
14.
Attach bottom of name panel #5 to U-supports #7. Secure with hex
bolts #9 and locknuts #15. Tighten nuts but be careful not to crush
tubes. See Figure 6.
15.
17.
Prepare an area for the assembly of the second table top half. If neces-
sary, move the first table top half aside with the aid of a helper. Be sure
to place it in a location where it won't be disturbed or damaged. If
setting on its side, be sure to place the bottom edge no less than 12
inches away form the wall. Also be sure to place carpet or pieces of the
shipping carton down to protect table top edges. If floor is not car-
peted, brace table top half with a heavy object to keep it from sliding.
16.
AT LEAST TWO ADULTS ARE NEEDED
TO MOVE TABLE HALF!
CAUTION:
Gently tap caster sockets #12 into U-support #7 until flange on sock -
ets touches the edge of the tube.
DO NOT HIT CASTER SOCKET
DIRECTLY WITH A HAMMER! SET A PIECE OF WOOD
ON CASTER SOCKET AND HIT PIECE OF WOOD TO
DRIVE CASTER SOCKET INTO U-SUPPORT.
Insert casters #11 into caster sockets #12.
Figure 8
Figure 7
Attach Strap #6 to the
INSIDE
of U-Leg #2.
Figure 6
29