Stiga EXPERIENCE Estate 798e, Руководство оператора

Страница: 308 / 1052

EN - 22
Status Action Result
Machine ON and Operating. Release the drive pedal. The machine slows down and stops.
Machine ON and Operating. Test drive. No unusual vibrations, no unusual
sound, correct operation of the
steering, controls and pedals.
DANGER
If any results do not to match the indications
in the tables, do not use the machine!
Contact an Authorised Service Centre to
have it checked and repaired if necessary.
NOTE
Always bear in mind that the safety devices
prevent the electric engine from starting if safety
requirements have not been met. In such cases,
once start-up consent has been reset, remove
the key before starting the machine again.
7.3 USING ON SLOPES
Comply with the limits indicated in the
"Technical Data" Tables as in "fig. 18"
regardless of the mowing direction.
Remember there is no such thing as a "safe”
slope. Driving on grass slopes requires
particular care. To prevent overturning
or loss of control over the machine:
• Never mow across the face of the slope.
Lawns on slopes must be mowed by moving
up and down and never across them in
forward gear. When changing direction,
take great care that the wheels facing the
slope do not hit any obstacles (such as
stones, branches, roots, etc.) that may
cause the machine to slide sideways,
tip over or make you lose control.
• Do not stop or start suddenly
when going up or downhill;
• Shift to drive gear very gently paying
particular attention to prevent the
machine from tipping up.
• Reduce speed:
• before changing direction
and during tight turns
• before tackling a slope, especially downhill,
to ensure a safe braking distance.
• Never switch to reverse gear to decrease
speed when going downhill: this could
cause loss of control of the machine,
especially on slippery ground.
7.4 START-UP
To start the machine:
1. Check that the transmission
is engaged (par. 6.3).
2. Sit in the operator’s position.
3. Fully insert the key (fig. 12.A).
a. For models type “I” and “II”:
4. Wait for the machine's electrical check
to be performed, during which the icons
on the pushbutton panel will flash.
5. Press the power button (Fig. 13.A).
6. Wait until the "Ready" icon
(fig. 13.K) is ON steady.
b. For models type “III”:
4. Wait for the electrical check of the
machine to be performed, during which
the icons present within the central
circular area of the pushbutton panel
light up (fig. 13III.F, 13III.Y, 13III.Z).
5. Press the power button (Fig. 13.A).
6. Wait until the battery status icons (13.F
and 13.Y), the cutting height (13.W) and
the other active functions are illuminated.
NOTE
At the end of the electrical check, the
headlights light up for a moment.
7.5 OPERATION
7.5.1 Drive and transfers
When moving the machine:
1. disengage the cutting means (fig. 13.B);
2. bring the cutting means assembly
to the highest position;
3. Press the drive pedal to move the
machine in the required direction of
driving and set the required speed by
adjusting the pressure on the pedal.
4. Go to the work area.