Stiga Cruiser 430 Li 60 Series, Руководство оператора

Страница: 125 / 415

EN - 7
Adjust the cutting height as indicated in (par. 5.3).
6.1.4 Handle inclination adjustment (Fig.3/4)
Do this when the cutting means is stationary.
6.2 SAFETY CHECKS
Run the following safety checks and check that the
results correspond to those outlined on the tables.
Always carry out the safety checks before use.
6.2.1 General safety check
Object Result
Grips Clean, dry.
Handle Fixed firmly to the machine.
Cutting means Clean, not damaged
or worn.
Rear discharge guard;
grass catcher
Good condition. No
damage. Properly installed.
Side discharge guard,
side discharge chute
Good condition. No
damage. Properly installed.
Control lever
Drive lever
The lever must move
freely, it must not need
forcing and should
return automatically
and rapidly back to
the neutral position.
Battery No damage to the casing,
no liquid leakage.
Screws/nuts on the
machine and on the
cutting means
Correctly tightened
(not loose).
Cooling air ducts Not clogged.
Machine No signs of damage
or wear.
6.2.2 Machine operating test
Action Result
1. Start the machine
(par. 6.3).
2. Release the switch
control (Fig. 19.A).
1. The cutting means
should move.
2. The lever should auto-
matically and quickly
return to neutral posi-
tion, the engine must
switch off and the cut -
ting means must stop
within a few seconds.
1. Start the machine
(par. 6.3).
2. Engage the drive
lever (par. 5.2.2 ).
3. Disengage the
drive lever.
1. The wheels should
move the machine
forward.
2. The wheels should
stop and the machine
stops moving forward.
Test driving No abnormal vibrations.
No abnormal sound.
If any of the results fail to match the indications
provided in the tables, do not use the machine! Contact
a service centre to have it checked and repaired if ne-
cessary.
6.3 START-UP
NOTE Start up the machine on a flat
surface without obstacles or high grass.
1. Open the hatch for accessing the battery com -
partment (Fig.15.A).
2. Insert the battery (Fig.15.B) in its housing pres -
sing down until you hear it clicks firmly into
position, in ensuring the electrical contact.
3. . Insert the safety key (Fig.15.C).
4. Completely close the hatch again.
5. Press the safety button (Fig.16.A) and
pull the control lever (Fig.16.B).
6.4 OPERATION
IMPORTANT When working, always keep
a safe distance from the cutting means,
given by the length of the handle.
Battery power reserve (and therefore the movable
lawn surface before recharging is required) depends
on many factors described in (par. 7.2.1).
IMPORTANT If the motor stops because
it is overheated while mowing, you must wait
approximately 5 minutes before restarting it.
6.4.1 Grass cutting
1. Start moving forward and mowing in the grass area.
2. Regulate the forward speed and the cutting
height (par. 5.4) considering the conditions of
the lawn (the height, density and dampness of
the grass) and the amount of grass collected.
On models equipped with feed rate
adjustment (Fig. 9.B): We recommend not
to work land that slopes more than 15°.