Stiga COMBI MULTICLIP, Руководство пользователя, Страница: 11 / 12

ENGLISH
GB
If the machine is to stand on its end, the
petrol and engine oil must have been
drained out first.
3. Set the lowest cutting height and remove the
locking pin Q (fig. 14).
4. Remove the two rear locking pins R and the ca-
bles for the switch contact on the deck (fig. 15).
5. Force the belt off the pulley (bend the belt guide
S upwards) (fig. 16).
6. Lift off the deck.
REPLACING V-BELT
ENGINE - CUTTING DECK
1. Remove the cutting deck (see above).
2. Remove the belt loop T. Remove the old belt
(fig. 17).
3. Install a new genuine belt in reverse order.
REPLACING V-BELT
ENGINE - TRANSMISSION
1. Apply the parking brake.
2. Lift the machine and stand it on its end.
If the machine is to stand on its end, the
petrol and engine oil must have been
drained out first.
3. Remove the cutting deck (see above).
4. Undo spring U and remove the belt idler V (fig.
16).
5. Disconnect the belt guide X and turn it to one
side.
6. Force the defective belt over the transmission’s
belt pulley. Work from the machine’s upper side.
Use the hole in the base plate.
7. Force the belt over the engine belt pulley. Bend
down the belt guide S and place the belt in the low-
er groove. Bend up the belt guide and remove the
defective belt.
8. Install a new genuine belt in reverse order.
ADJUSTING BLADE BRAKE
1. Set the blade engaging lever in the rear, disen-
gaged position.
2. Undo the blade brake Y and adjust so that it is
lying flush with the belt pulley (fig. 17).
3. Tighten screw and nut.
Replace the brake lining when it is worn.
BLADE
Ensure that the blade is always sharp. This produc-
es the best cutting results.
SHARPENING
For safety reasons, the blade should not be sharp-
ened on an emery wheel. Incorrect sharpening (=
too high temperature) could cause the blade to be-
come brittle.
Sharpening of the blades must be done by wet
method grinding, using a whetstone or a grind-
stone.
Once the blade has been sharpened, it
must then be balanced to avoid vibra-
tion damage.
REPLACING THE BLADE
When replacing the blade, blade holder and blade
screw – always use genuine spare parts.
Always use original spare parts. Non-
genuine spare parts can entail a risk of
injury, even if they fit the machine.
When replacing the blade, the centre bolt should
also be replaced. This is equipped with a lock.
Blade screw tightening torque: 65 Nm.
SPARE PARTS
STIGA genuine spare parts and accessories are de-
signed specifically for STIGA machines. Please
note that ‘non-genuine’ spare parts and accessories
have not been checked or approved by STIGA.
The use of such parts and accessories
can affect the function and safety of the
machine. STIGA accepts no responsi-
bility for damage or injuries caused by
such products.
STIGA reserves the right to make alterations to the product
without prior notification.