17
User’s manual
EN
BATTERY CHARGING ON FIRST USE
1.
Place the robot inside the charging station.
2.
Press the ON key.
3.
After a few seconds, the “CHARGING” message will appear on the
display.
4.
Press the “Start/Pause” key. The “PAUSE” function appears on the
display. The batteries start the charging cycle.
5.
At the end of charging, the robot can be programmed for initial start-up
(see “Programming Mode”).
ENTER
“ON” KEY
“START/PAUSE” KEY
Important
On
fi
rst use, always charge the batteries for at least 4 hours.
ADJUSTMENTS
ADJUSTMENT RECOMMENDATIONS
Important
The user must make any adjustments according to the procedures described in this manual. Do not make any adjustments
which are not expressly indicated in this manual. Any special adjustments, not expressly indicated in this manual, must
only be performed by personnel from the Manufacturer’s authorised service centre.
ADJUSTMENT OF CUTTING HEIGHT
Before setting the cutting height of the blade, make sure the robot is safely off (see “Robot Safety Stop”).
Important
Use protective gloves to prevent injuries to your hands.
1.
Unfasten the lid and lift it.
2.
Unfasten the lid of the two side arms and lift it.
3.
Loosen the screw (C).
4.
Lift or lower the cutting group (D) to de
fi
ne the desired height. This can
be found on the graduated scale.
5.
Tighten the screw (C) until the adjustment is made.
6.
Repeat the operations from point 3 for all motors, making sure that you
adjust them all to the same height.
Important
Do not use the robot to mow grass which is 1 cm (0.40 ")
higher than the cutting blade. Reduce the cutting height
gradually. It is recommended to reduce the height by at
least 1 cm (0.40 ") every 1-2 days until the ideal height is
reached.
7.
Lower and fasten the lid with the side arms.
8.
Lower and fasten the robot lid.
(D)
(C)
