Stiga 8211-0007-70 Скачать руководство пользователя страница 11

62

ENGLISH

EN

Only fill or top up with fuel outdoors, 
and never smoke when filling or top-
ping up. Fill with fuel before starting 
the engine. 
Never remove the fuel cap or fill with 
fuel while the engine is running or still 
warm.

4.2 Bleeding

The engine’s fuel system must be bled in the fol-

lowing instances:
• If the fuel tank has been run dry and air has been 

drawn into the fuel system.

• After replacing the filter.
Bleed as follows:
1. Fill the tank with fuel.
2. Pump using the hand pump (10:Y) until all air 

has been pumped out.

4.3 Level check, engine oil

On delivery, the crankcase is filled with SAE 10W-
40 oil.

Always check the oil level before use to ensure it 
is correct. The machine should be standing on 
level ground.

Check the oil level as follows:

1. Wipe around the dipstick. 
2. Unscrew and pull the dipstick up. 
3. Wipe the dipstick. 
4. Slide the dipstick down completely and pull up 

again. 

5. Read off the oil level. The oil level should be at 

the “Max” mark as illustrated in fig. 11.

If the oil level is below the “Max” mark in fig. 11, 

fill with oil as follows:
1. Unscrew the oil filler cap (11:C).
2. Fill with the necessary amount of oil. Applica-

ble oil types, see “5.4”.

3. Check the level as above.
4. When the level is correct, reinstall the oil filler 

cap and tighten.

The oil level must never exceed the “Max” mark as 

illustrated in fig. 11. This can cause the engine to 

overheat. Drain the oil to the correct level if the oil 

level exceeds the “Max” mark.

4.4 Level check, transmission oil

See 5.8.1.

4.5 Safety checks

Check that the results of the safety checks below 

are achieved when testing the machine in question.

The safety checks must always be car-

ried out every time before use.
If any of the results below is not 

achieved, the machine must not be 

used! Take the machine to a service 

workshop for repair.

4.5.1 General safety check

4.5.2 Electrical safety check

The operation of the safety system 

should always be checked every time 

before use.

Object

Result

Fuel lines and con-

nections.

No leaks.

Electrical cables.

All insulation intact.

No mechanical damage.

Exhaust system.

No leaks at connections.

All screws tightened.

Oil lines

No leaks. No damage.

Drive the machine 

forwards/back-

wards and release 

the driving-service 

brake pedal.

The machine will stop.

Test driving

No abnormal vibrations.

No abnormal sound.

Status

Action

Result

The clutch-brake 

pedal is not 

depressed.

The power take-off 

is not activated.

Try to start.

The engine 

will not start.

The clutch-brake 

pedal is depressed.

The power take-off 

is activated.

The driver gets up 

from the seat.

The engine 

will not start.

Engine running. 

The power take-off 

is activated.

The driver gets up 

from the seat.

The power 

take-off will 

be disen-

gaged.

Status

Action

Result

Cruise control acti-

vated.(4WD)

The driver gets up 

from the seat.

The cruise 

control will 

be disen-

gaged.

Cruise control acti-

vated. (4WD)

The clutch-brake 

pedal is depressed.

The cruise 

control will 

be disen-

gaged.

Содержание 8211-0007-70


















Отзывы: