EN
G
L
ISH
INSTALLATION
SIDE BY SIDE ACROSS WITH SUPPORT
SOL BB
| 37
8.3 Fitting roof hook
8
2
_0
5_0
1
_0
0
3
7
VĒĒÏäĒĒ÷ńĤ|êĉÖ
ĉÖù¼ĒÏêĉùêĉ|ŒêĒĉ
30°
mm
1220
±200
859
-400
f
Remove the roof tiles up to the next rafter or push them
to one side.
2
6
_0
5_0
1
_0
5
9
8
2
1
1 Fixing plate
2 Roof hooks
f
Secure each roof hook to the roof rafter using at least two
woodscrews.
f
Align the roof hooks. Use the support plate to compen-
sate differences in height.
f
Tie a guide line between the outer roof hooks of the
planned collector array. Align any other roof hooks to this.
f
Replace the roof tiles.
8.4 Support
f
Trim the support strips to the required length. You only
need one support strip for an angle of 15°. Join two sup-
port strips together for an angle of 30°.
8.4.1 Fitting the support on the top roof hooks
2
6
_0
5_0
1
_066
5
f
Secure an L-bracket on the top roof hooks so that the
short side is at the top.
f
Secure the support strip to the short side of this L-bracket.
f
Secure an additional L-bracket with its short side to the
top end of the support.
8.4.2 Fitting the L-bracket to the lower roof hooks
2
6
_0
5_0
1
_066
4
18
19
9
16
17
8
2
2 Roof hooks
8 M10 nut
9 Screw M10
16 Pivoting bracket
17 Screw M6
18 M6 nut
19 M6 washer
f
Secure one L-bracket with a M10 screw and a M10 nut to
the roof hook. Insert the screw through the centre hole
on the long side of the L-bracket. The short side of the L-
bracket must be at the top.
f
Secure the short side of the second L-bracket to the short
side of the L-bracket fitted to the roof hook. Use the M6
screw, washer and nut.
