STIEBEL ELTRON SBS 1000 W, Эксплуатация и установка, Страница: 14 / 52

installation
safety
14 | sBs w | sBs w sol www.stiebel-eltron.com
installation
Safety 4.
general safety instructions 4.1
The installation and commissioning must only be carried out by a
contractor. During this process the installation instructions must
be observed.
We guarantee trouble-free function and operational reliability
only if the original accessories and spare parts intended for the
appliance are used.
Instructions, standards and regulations 4.2
Water installation 4.2.1
DIN 1988: Technical rules for potable water installations
DIN 4109
Regulations of the relevant water utility company.
Cold water pipe material: Steel, copper or plastic pipe systems.
Hot water pipe material; Copper or plastic pipework systems.
Any plastic pipework system must be designed to withstand the
maximum possible conditions (temperature and pressure) in the
event of a fault.
Energy Saving Act (ENEG) 4.2.2
The hot water pipe must have thermal insulation. —
The DHW temperature in the pipework is restricted to a maximum —
of 60 °C through automatic devices or other measures. This does
not apply to DHW systems that require higher temperatures or
need cable lengths of less than 5 m.
DHW systems shall be equipped with automatic devices to shut
—
down the circulation pump.
Equipment description 5.
SBS 800 | 1000 | 1500 w | w Sol 5.1
The connector allocations for
heat pump flow and return —
additional heat source flow and return —
heating flow and return —
are matched to the standard system scheme.
Alternative allocations for different system components are
possible.
Modified connector allocations and non-observance of the intended
maximum flow rate can impair the delivery capacity.
Hydraulic connector allocation 5.1.1
15
Connector allocation SBS 800 | 1000 | 1500 W | W SOL
C2
6�
03
�0
1�
09
32
1
4
13
5
3
9
7
6
14
8
2
11
12
17
10
16
Hot water 1
Cold water 2
Additional heat source flow 3
Additional heat source return 4
Heat pump flow, DHW 5
Heat pump return, DHW 6
Heating flow 7
Heating return 8
Heat pump flow, heating 9
Heat pump return, heating 10
Internal indirect coil solar, flow (only SBS...W SOL) 11
Internal indirect coil solar, return (only SBS...W SOL) 12
Connector for threaded immersion heater BGC 13
Drain connector 14
Air vent valve connector 15
Type plate 16
Lifting eyes 17