INSTALLATIoN
Safety
www.stiebel-eltron.com
CK 20 S | CKZ 20 S | CKR 20 S | CKT 20 S |
19
EN
GL
ISH
INSTALLATIoN
11. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
11.1 General safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
11.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regulations
and instructions.
12. Appliance description
This appliance is a wall mounted electric direct heater. This ap-
pliance is particularly suitable for heating rooms, such as work
rooms, kitchens, bathrooms, wash rooms etc.
12.1 Standard delivery
The following are delivered with the appliance:
- Wall mounting bracket
- Fixing bracket
13. Preparations
13.1 Minimum clearances
≥
10
≥100
≥100
≥500
≥100
≥100
D
00000
184
81
14. Installation
WARNING Electrocution
-
If installing the appliance in rooms with a bath
and/or shower, take the relevant safety zone into
account in accordance with the information on the
appliance type plate.
-
Install the appliance in such a way that control
equipment cannot be touched by a person in the
bath or shower.
WARNING Burns
-
Only fit the appliance to a vertical wall that is tem-
perature-resistant to at least 90 °C.
-
Maintain minimum clearances to adjacent surfaces.
-
Never install the appliance directly below a wall
socket.
f
f
Check the hole distances for the wall mounting bracket in the
dimensioned drawing.
f
f
Secure the wall mounting bracket with suitable fixing mate-
rials. The horizontal and vertical slots in the wall mounting
bracket enable alignment if drilled holes are not completely
accurate.
f
f
Position the appliance against the wall so that the two pro-
trusions in the top of the back panel grip into the slots in the
wall mounting bracket.
f
f
Secure the appliance with the mounting bracket and one
screw to prevent unintentional unhooking. Hook the mount-
ing bracket into the back panel from the lower rear.
15. Power supply
WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
!
Material losses
Observe the type plate. The specified voltage must match
the mains voltage.
- The cable must not touch the appliance.
- When connecting the appliance via a standard socket, ensure
that this is easily accessible once the appliance has been
installed.
- Never install the appliance directly below a wall socket.
- If a permanent connection is required, trim the cable (cut
off the plug) so that it runs directly to the appliance junction
box.
- In the case of a permanent connection, the appliance must
be able to be separated from the power supply by an iso-
lator that disconnects all poles with at least 3 mm contact
separation.
- This appliance is unsuitable for fixed cables.
