UHF
Desktop Reader
Installation instruction
UHF
Lecteur de table
Notice d’installation
UHF
Lector de mesa
Procedimiento de instalación
conforme con
NOM-024 -SCFI-2013
© STid - 20 PA des Pradeaux FR13850 Gréasque - NI1148C04- Page
2
sur
7
-
Ed. 04/01/2023
STid reserves the right to make change without notice, for the purpose of product improvement.
When the reader is in Keyboard emulation ON,
the only command accepted is Keyboard
emulation OFF
.
Dimensions
Declaration of Compliance
STid declares that the ARC-W45-G & ARC-W55-G readers is compliant to the fundamental requirements of Directive RED
2014/53/EU and Directive RoHs 2011/65/EU and Commission Delegated Directive 2015/863/EU. A copy of our declaration is
available upon request send to
This device complies with Part 15 of the FCC rules and with Innovation, Science and Economic Development Canada’s license
-
exempt RSS(s). Operation is subject to the following two conditions:
1) This device must not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Suc
h modifications could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can emit radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-
Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
-
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for assistance.
This equipment complies with FCC’s
and ISEDC's radiation exposure limits (using RSS-102 rules) set forth for an uncontrolled
environment under the following conditions:
-
This equipment should be installed and operated such that a minimum separation distance of 34 cm / 13.39 in
is
maintained between the radiator (antenna) and the user’s/nearby person’s body at all times.
-
The transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with CAN ICES-003(B) / NMB-003(B).
3.15 in / 80,0 mm
1.09 in / 27,7 mm
4
.2
2
in
/
1
0
7,1
m
m
General tolerance following ISO
NFT 58-000 standard.
