STICKY BRICK
HYDROBRICK MAXX
~1"
INNER FLAME
OUTER FLAME
B
HEAT
INTAKE
E
C
D
SMALL BRICK
INNER LEDGE
HEAT INTAKE
O-RING
AIR INTAKE
SCREEN
CHAMBER
CARB
CARB CORK
(OPTIONAL)
18MM JOINT
O-RINGS
BASE
LID
STORAGE JAR
INTAKE STORAGE
A
PREPARE
Remove lid and set aside. Move heat
•
intake from storage position to small brick.
O-ring should be placed into wood before
the glass for best seal.
Adjust torch so overall flame length is ~1".
•
LOAD
Hold the base in one hand and twist the small
brick to break the magnetic connection and
expose chamber ( A ). Load ground
material loosely into chamber no higher than
the inner ledge so it evenly covers the
screen. Reassemble the Bricks.
OPERATE
Aim torch flame down heat intake, and
•
position flame so the light blue outer flame
is flush with, or just inside, the intake ( B ).
Cover carb and draw slowly until you
•
see/taste/feel vapor. Increase draw speed.
As you finish the draw, remove torch and
•
open carb.
Stir material between draws as needed.
•
Do not cover air intake on the side of the
•
unit as it provides needed, continuous
airflow. Glass retains heat, so do not touch
heat intake immediately after use.
OPTIONS
The included carb cork can be used to
•
block the carb to free up a hand and
produce thicker vapor.
The HydroBrick's 18mm joint is compatible
•
with a variety of accessories: the included
dry mouthpiece ( C ), hydratubes ( D ),
or the included whip ( E ) to connect your
favorite glass. These items are available for
purchase at stickybricklabs.com
