STI P/M STI-2418LP, Руководство по эксплуатации

Страница: 7 / 40

Operating Manual STI-2420 | STI-2418LP
5
Electrical Warning
Warning against dangerous voltages.
2.2 Organizational Measures
The Operating Instructions are to be kept near the location where the machine is
located and must be accessible all the time!
In addition to the Operating Instructions general and legal regulations regarding accident
prevention and environmental protection must be with and indicated every time!
Such duties may for example relate to the handling of hazardous substances or to the
provision and wearing of personal protection equipment as well as compliance with local
traffic regulations.
The Operating Instructions must be supplemented by instructions including the duty
to supervise and report relating to particular local working practices, for example work
organization, work procedures, and personnel allocation.
Personnel entrusted with working with the machine must have read the Operating
Instructions before starting the work; in particular the chapter about Safety Instructions.
These have to be read before starting any work with the machine. This particularly applies
to incidental activities such as setting up the machine, carrying out maintenance work, or
training staff to work with the machine.
From time to time the working practices of the staff are to be checked regarding awareness
of safety and hazards.
Personnel must tie back long hair and not wear loose clothing or jewelry and rings. There is a
risk of injury through getting stuck or being drawn into moving machinery.
Use personal protection equipment if necessary or required by regulations!
Take notice of all safety and hazard notices on the machine.
All safety and hazard notices on the machine must be kept complete and legible.
If safety-critical changes occur to the machine or its performance, the machine must be shut
down immediately! The cause of the fault has to be established immediately and has to be
repaired before starting the work again.
Changes, add-ons, or conversions of the machine which might have an influence
to the safety of the machine must not be undertaken without the permission of the
manufacturer.