— 5 —
Enrolling Sensors into Zones
1.
Check that the module is not in DELETE mode (SW7 OFF).
2.
If the zone should have “latching” set (SW3 ON).
3.
Enable ENROLL mode set (SW2 ON).
4.
Check that the zone flashing GREEN is correct, and note the zone(s) with RED LEDs.
5.
Change the status of the SENSOR to be enrolled by triggering an alert on the SENSOR and return it to the non-triggered
state (if done manually).
6.
The RECEIVER will give a double beep and the zone LED will change to continuous RED.
7.
Repeat steps 2-6 to enroll another SENSOR.
8.
To exit ENROLL mode set (SW2 OFF).
ZONE ENROLLING AND DELETING PROCEDURES
The STI 8-Channel Receiver is designed to receive ONLY wireless signals from products in the
STI Alert Series
(see back of
the installation instructions). The RECEIVER allows you to enroll up to 8 devices into zones 1 thru 8. The RECEIVER will enroll
from different SENSORS directly or by enrolling other mirrored RECEIVERS. The RECEIVER also enrolls up to eight keyfobs.
When ENROLL mode is enabled (SW2 ON), the LEDs for any currently enrolled zones will turn RED to indicate these zones
are not available. The LED will flash GREEN to indicate the available zone to be enrolled. Press the push button to change
to a different zone to be enrolled. The next available zone will have the flashing GREEN LED. The RECEIVER will not allow
enrollment into an occupied zone. The RECEIVER will not allow the same device to be enrolled into more than one zone.
The RECEIVER will not enter ENROLL mode while it is in DELETE mode (i.e. DIP SW7 ON).
Zone Latching
“Latching” lets you know a zone alert was previously triggered but the alert has also been cleared. When a zone is in the
“latched” status, the zone LED will flash RED. For example, when a door SENSOR has been opened and closed, the zone LED
will flash RED to indicate the door was opened previously, but is no longer opened.
The latching is released when the user presses the push button to indicate acknowledgement of the alert. When the “latched”
status is released, the zone LED will change back to continuous GREEN. If the zone has another alert before the “latched”
status is released, the LED will change to continuous RED in the alert state, and then back to flashing when the alert is cleared.
A zone will have “latching” when SW3 is (ON) at the time of enrollment. If zone latching is not selected at the time of enrollment
(SW3 OFF), the zone LED will change from continuous RED back to continuous GREEN when the alert has been cleared.
Low Battery / Tamper Detection / Out of Range SENSOR Alerts
If the battery is too weak, something has triggered a tamper alert signal from the SENSOR, or the SENSOR has been out of range
between 12 - 24 hours, the zone LED will light AMBER to alert a need for attention to that device.
Sensor Installation Tip
When first enrolling a SENSOR, set the “latching” on (SW3 ON), and bring the SENSOR to the RECEIVER location to enroll it
before mounting the SENSOR. Then, mount the SENSOR at its intended location and trigger an alert on the SENSOR. Check
the zone on the RECEIVER to see if it is continuous RED or flashing RED, which means it received the SENSOR’S signal. Then,
if latching is not desired, delete that zone (see
Deleting Single Zones
) and enroll the SENSOR again without latching (SW3
OFF), from the mounted location.
See Enrolling Mirrored (multiple) Receivers
