2.4.2 Unbalanced Input Connections
When using an unbalanced input source and connector, a jumper must
be added between the negative (-) terminals and the ground terminals.
Once this has been done, the unbalanced source can be connected to
the positive (+) and ground terminals. Please refer to the manual of
your input source in case it does not follow the standard pin-out. For
your convenience, pre-wired connectors are available for purchase, see
the next page for details.
NOTE: A jumper is
required
for connecting an unbalanced
input.
NOTE: The CVA Series of amplifiers do not accept stereo
inputs. Either one side must be selected from the stereo
source or an overload-protected Y-cable must be used to
sum them to mono. It is highly recommended that you
purchase the pre-wired connectors mentioned on the next
page. Damage to source equipment can result from the
10
