TIGER Chipper Shredder CS7-205V & CS7-305V Owners Manual (P/N 1432)
page 5
Preventing accidents is the responsibility of every equipment owner. Ensure you have been instructed by your
authorised dealer on all safety issues, both general and specific and the operation and maintenance of the chipper
shredder before operating machinery.
Intended uses of machine
Do not use for any purpose other than for which the machine is designed. If you have any doubts contact your
authorised dealer. Do not modify the design of the machine.
Operator Competency
Do not allow persons to operate machinery without full and proper instruction in the use of the machine,
adjustments maintenance and the factors of safe operation.
Safe Operating Procedures
•
Safety equipment must be worn while operating chipper, i.e. safety glasses, ear muffs and work gloves.
Persons not wearing safety equipment should not be close to an operating machine.
•
Avoid wearing loose
-
fitting clothing.
•
Before starting the machine, check that all screws, nuts, bolts, and other fasteners are properly secured and
guards and screens in place. Replace damaged or unreadable warning and operating labels.
•
Use extra care in handling fuels. They are flammable and vapours are explosive.
-
Use only an approved container.
-
Never remove fuel cap or add fuel with the engine running. Allow engine to cool before refuelling.
-
Do not smoke.
-
Never refuel the machine indoors.
-
Never store the machine or fuel container inside where there is an open flame, such as a water heater.
-
If fuel is spilled, do not attempt to start the engine, but move the machine away from the area of
spillage
before starting.
-
Always replace and securely tighten fuel cap after refuelling.
•
Before starting, ensure the chipper is positioned on level ground. Do not operate the machine on a paved or
gravel surface where ejected material could cause injury.
•
Keep children and spectators clear of the work area at all times and do not operate the machine where there
is an immediate hazard to onlookers.
•
Do not allow children to operate this equipment.
•
Do not put your hands or any other part of the body more halfway into the infeed chute, or near any moving
part. Keep your face and body away from the infeed and discharge opening.
•
Carbon monoxide can be extremely dangerous in enclosed areas; do not run the machine in an enclosed area
since the exhaust from the engine contains carbon monoxide, which is colourless, odourless, and tasteless.
•
Always shut down the machine before shifting it.
•
Always make sure that the engine is shut down and that the cutting disk and engine are at a complete
standstill before opening the cutting disk housing.
•
Before inspecting or servicing any part of the machine, shut off the power source, disconnect the spark plug
wire from the spark plug, and make sure that all moving parts have come to a complete stop.
Safety
