Fuselage Cont.
Upper Decking Cont.
23.
Fit and bond two stringers F19 to the next set of notches on either side of F18.
24.
Fit and bond two stringers F20 to the next set of notches out from stringers F19.
25.
Fit and bond the
outer
stringers F21 to the last set of notches out from stringers F20, just
above the fuselage sides.
26.
Fit and bond former F22 to the notch in F1 immediately in
front
of and against former F3.
27.
Fit and bond former F23 to the notch in F1
between
formers F2 and F22.
28.
Locate the fuselage sheeting F24 and moisten the etched side with glass cleaner, allowing
it to soak in for a minute or two.
While you wait on F24 to soak, flip to “Step 75” and read the “Builder Tip” to determine if
you’d like to pre-install your motor and gearbox now.
29.
Fit F24 to the tabs in formers F19, F2, and F23, with the etched and moist side up.
30.
Wrap F24 around the formers F9, F2, and F23 bringing the
left
and
right
edges of part F24
flush with the
upper
edges of the fuselage sides. The
aft
end of F24 will wrap around F22
with the split portion of F24 coming together at the top of F22. Now do not bond, instead,
hold F24 in place with low tack masking tape until completely dry.
Build Instructions
SE5.a UM Build Instructions. © 2013 Stevens AeroModel all rights reserved.
!
Page 14
□
□
□
□
□
□
□
□
