Final Assembly Continued
Control Linkages
53. - Refer to the aileron plan on the detail sheet for positioning the aileron
horns. The
LEFT
aileron will have the horn extending below the aileron,
from the
OUTER
slot. The
RIGHT
aileron will have the horn extending
below the aileron, from the
INNER
slot. Bond the horns to the ailerons with
thin CA.
54. Mount the elevator horn to the
BOTTOM RIGHT
of the elevator.
55. Mount the rudder horn extending from the
LEFT
side of the rudder.
56. Pre-shrink the length of heat-shrink tube supplied in your kit. Slip it over
TWO lengths of 0.015 wire, and shrink with a heat gun. When cool, remove
the wire and cut the tube into 1/2 in lengths.
57. Study the Pushrod Detail on the detail sheet, and make a small snake bend
in one end of a length of 0.015 wire (part “A”). Poke a hole in the covering
over the exit slot on the
BOTTOM
of the wing, to the
RIGHT
of the fuselage.
Carefully twist the snake bend end of the wire to fish it through the slot.
Feed the wire through until it enters the radio compartment.
58. Connect the wire to the middle hole on the elevator servo tab. Refer to the
diagram of the receiver on the detail sheet to identify the elevator servo.
59. Cut two 1/4 in. pieces from the yellow nylon tube supplied in you kit.
Build Instructions September 8, 2011
!
(c) 2011 Stevens AeroModel all rights reserved.
!
Page 20
☐
☐
☐
☐
☐
☐
☐
☐
☐
