Wing Construction Continued
Build the wing center section from W1
sheeting (previous assembly of W1a/W1b),
ribs R1, and ply spar S1. Key ribs R1 to the
spar S1 using the notches in the spar as a
reference for spacing. Glue.
Next, aligning with the tabs on ribs R1, wrap
center section sheeting W1 assembly over R1
ribs and glue in place.
Edge of W1 follows centerline of ribs R1.
Join completed right and left wing panel to
completed wing center section.
Fit the spar S1 to the notch in the bottom of
ribs R2 and R3.
Wing root edge should align with tabs in ribs
R2 and fit flush with edge of center section
sheeting. Once satisfied with alignment, glue.
PuddleBug © 2010 Stevens AeroModel all rights reserved.
Page 7 of 13
