Project Checklist
Kit Contents
Laser cut wood (5 Sheets - See inventory on following pages)
Illustrated instruction manual - Available for Download Only
Computer drawn 11x17 plan set (2 Pages)
Laser cut profile pilot figure, assorted color (Courtesy of Kris Cartwright)
Taped to Back of Wood Brick
2 - 12 in. Length of 0.015 in. dia. Wire
1 - 12 in. Length of 0.025 in. dia. Wire
1 - 12 in. Length of 0.020 in. dia. Carbon Rod
Hardware Bag (4 x 6 in.)
1 - 1.5 in. Length of 1/16 in. dia. heat shrink tube
1 - 3.0 in. Length of 1/2 in. Velcro (non sticky back)
2 - Delrin Wheels
Required Electronics
(Available at StevensAero.com)
Spektrum compatible radio with servo reversing. We suggest the DX5e (DX6i if using AR6400).
ParkZone [PKZ3351] or Spektrum [AR6400] Ultra Micro Receiver/ESC/Servo System.
ParkZone Motor and Gearbox [PKZ3624] (Same motor as used in the Sukhoi and UM P-51)
ParkZone UM P-51 Propeller [PKZ3601] or E-Flite [EFL9051] 130mm x 70mm propeller.
ParkZone [PKZ1035] or E-Flite [EFLB1201S] 110-120mAh 3.7V LiPo Battery
LiddleRod™ © 2010 Stevens AeroModel all rights reserved.
Page 3 of 14
Required Building Supplies and Tools
1/2 oz. Medium CA Glue
1/2 oz. Thin CA Glue
CA glue accelerator (kicker)
Hobby Knife with ample supply of #11 blades
Sanding block with 400 and 600 grit paper
Covering Iron and Heat Gun
Small Needle Nose Pliers
Small Round “Rat-Tail” file.
1 in. x 2 in. length sticky back velcro
3/4 in. wide clear tape
1 Roll AeroLITE (solite)
Suggested Building Supplies
CA glue de-bonder
Long sanding bar
Low Tack Painters Masking Tape
Dubro Servo Tape [DUB-634]
