Fuselage Continued
9.
Radio Tray - Lay F9 on the table with the etched side facing up. The forward edge of F9 is
indicated by the etched arrows. Note that the tabs on each end of parts F10 and F11 are
different sizes, left to right. These will fit in the appropriate sized slots in F9, thus ensuring
proper left/right orientation.
Fit parts F10 and F11 to the nylon receiver clip found in your
hardware bag. Orient the long arm of the receiver clip nearest to F10, with the etched side
of F10 facing toward the long arm. Fit ply parts F10 and F11 to the slots in F9. F10 will fit
in the forward set of slots, and F11 in the rear set of slots.
Do not force the fit!
If you have
difficulty fitting the receiver tray assembly to F9, double check the orientation of F10 and
F11 - ensuring that the large tabs fit in the large slots, etc. Check the orientation of all parts
with the photo for this step, then bond with CA.
10.
Fit the tabs at the forward end of F9 (indicated by the etched arrows) to the notches at the
top of the opening in the middle of former F8 - refer to the photo for this step for proper
orientation.
11.
Fit former F12 to the tabs at the rear of F9, and to the slots in F1 directly below. Ensure
that the etched side faces forward.
12.
Fit former F13 to the slots in the cross piece F1b, ensuring that the etched side faces
forward.
13.
Fuselage Sides - Fit
left
fuselage side F14 to the tabs on the
left
side of former F12.
Tack
glue F14 to F12 only
.
14.
Fit
right
fuselage side F15 to the
right
side of former F12, tack gluing the two parts together.
15.
Pull the fuselage sides together at the rear, engaging the tabs along the side of F1 and
former F13. Square the assembly on a flat surface, and final bond the fuselage side to F1
and the formersF12 and F13.
16.
Pull the fuselage sides together in the middle of the assembly, engaging the tabs on F1, F8,
and F9. Square the assembly on a flat surface, and completely bond the fuselage sides to
F1, F8, and F9.
Build Instructions
1911 Cuadron Build Instructions. © 2013 Stevens AeroModel all rights reserved.
!
Page 10
□
□
□
□
□
□
□
□
