8
9
INsTallaTIoN
INsTallaTIoN
sTEP 3 – coNNEcTINg ThE waTEr suPPly
1
Connect the flexible pipe to the water
supply.
For models with temperature control
connect the red flexible pipe to the
hot water supply and the blue flexible
pipe to the cold water supply.
1 Inlet VerSIon
2 InletS VerSIon
for extreme Hl
Connect the Dual Power Input Box
inlet nipple to the water supply fitting
(A).
Connect the flexible pipe from the
faucet to the second connection of
the Dual Power Input Box (B).
A
B
makE surE ThaT ThE FIlTEr(s) Is/arE INsTallED BETwEEN ThE FlEXIBlE
PIPE aND ThE shuT oFF ValVE (aNglE ValVE) (NoT suPPlIED).
2
Turn on the central water supply and
the shut-off valves (angle valves) and
check for leaks.
sTEP 4 – coNNEcTINg ThE PowEr sourcE
1
BatterY VerSIon
Fix the battery box at the wall
underneath the sink using the screw.
The cable connection must point
down.
for extreme Hl:
Insert the 9V battery into the Dual
Power Input Box battery compartment.
tranSformer VerSIon
Plug the transformer into the electricity socket and connect the connectors.
for extreme Hl:
Insert the transformer connector
into the designated input of the Dual
Power Input Box, plug the transformer
into the electricity socket, and then
connect the connectors between the
sensor and the Dual Power Input Box.
2
In order to avoid entering into the
adjusting mode, wait 10 seconds
before operating the faucet. If the
range is unsatisfactory, refer to the
section titled “settings adjustment.
SECONDS
ABOUT
1o
NOTE: This model includes a special aerator
that allows you to adjust the water stream
direction on site in order to prevent water
splashing if needed. To change the angle of
the water stream, simply move the adjustable
tilting plate by pressing it smoothly.
ATTENTION! the aerator is tightened to prevent
removal by hand.
O-RING VISIBLE –NOT CONNECTED PROPERLY
ONLY THE GROOVES ARE VISIBLE – CONNECTED PROPERLY
