10
11
MALMO
1000
MALMO / MALMO 1000
10-pack Sensor Kit
07220374
10-pack Solenoid valve kit
07232000
Battery cover
06500001
Filter
0853001
3
Remote Control 13B (optional)
07100005
Soap & Water Remote Control (Optional)
07100014
MAINTENANCE
CARE AND CLEANING OF CHROME AND SPECIAL FINISHES
DO NOT use steel wool or cleansing agents containing alcohol, acid, abrasives, or
the like. Use of any prohibited cleaning or maintenance products or substances
could damage the surface of the faucet. For surface cleaning of faucet us ONLY soap
and water, then wipe dry with clean cloth or towel. When cleaning bathroom tile, the
faucets should be protected from any splattering of harsh cleansers.
h. Reassemble the faucet body to the base with the rosette setting the screw.
i. Re-establish the incoming water supply.
j. Make sure that there is no water leakage.
SPARE PARTS LIST
MALMO
FILTERS CLEANING INSTRUCTIONS FOR MALMO 1000
a. Shut-off the water supply and the valve.
b. Release the set screw at the faucet body using the 2 mm
Allen Key.
c. Pull out the Malmo 1000 body and separate it from the
rosette.
d. At this point you will have access to the two nipples and
the Allen screw that are located at the internal side
of Malmo 1000 faucet. Unscrew this screw using
the provided 4 mm Allen key.
e. Pull out the nipples and dismount the filters.
f. Wash the filters under running water. If needed,
replace the filters with new ones.
g. Restore the filters. Restore the nipples and close
the central screw using the Allen key.
MAINTENANCE
FILTER CLEANING INSTRUCTIONS FOR MALMO
This faucet is provided with a stainless steel filter preventing foreign particles to enter the
lines. If the water flow has decreased, this may be because the filter is clogged. The filter
can be cleaned as follows:
a. Shut-off the water supply and the valve.
b. Release the set screw at the faucet body using the 2.5 mm Allen Key. Disassemble the
faucet’s body from the base.
c. Disassemble the filter from the base.
d. Wash the filter under running water. If needed, replace the filter with a new one.
e. Restore the filter. Reassemble the faucet body to the base setting the screw.
f. Re-establish the incoming water supply.
g. Make sure that there is no water leakage.
