Harness Assembly:
Remove four (4) screws from vacuum housing inserts. Position harness
on vacuum housing. Align harness back plate with mounting holes to the vacuum body. Re-
insert four (4) screws through harness and tighten.
Adjusting Backpack Harness:
Loosen waist and chest belt latches. Slide arms through shoulder straps. Adjust
shoulder straps to raise or lower backpack so that the weight is evenly distributed between the back and hips, and the
waist and chest belt latches comfortably. For significantly shorter or taller operators, it may be necessary to adjust the
harness back-plate to find a comfortable position. The back-plate can be re-positioned by removing and relocat ing the
four (4) screws to the vacuum housing.
To Operate:
(
1) Pass the pigtail cord through the strap outside the left side of the waist belt. Pass your ex-
tension power cord (not provided with vacuum) through the plastic retaining clip hanging
from the harness. This will prevent the pigtail and extension power cord from separating
during operation.
(2) Place the pigtail switch box under the sewn strap and fasten the other strap
around the switch box.
(3) Fasten the waist belt and chest belt snugly and make sure the weight is resting
comfortably on your hips. Again, the back plate is adjustable up or down by re-
moving the four screws that attach to the vacuum’s body.
Thermal Protection:
The motor in this vacuum is protected with a thermal cutoff device. If an excessive high op-
erating temperature is detected, power to the motor will be cutoff. Excessive operating temperature can be caused by a
blocked vacuum hose or clogged filters. If thermal cutoff occurs, immediately turn off the vacuum and inspect for hose
blockage or full filter bag. Remove blockage and/or replace filter bag, then allow a few minutes for the vacuum to cool
down to reset thermal cutoff device before turning vacuum on.
WARNING
•
Unplug the vacuum when working on the motor or any electrical part.
•
Check the condition of all electrical cords before each use.
•
Do not lubricate the motor; it is equipped with sealed bearings.
•
The vacuum has no user serviceable parts.
•
Do not vacuum with a frayed, worn, or damaged cord.
•
Do not vacuum liquids or expose the canister vacuum to rain or water.
•
Do not vacuum hazardous or toxic materials without HEPA in place.
•
Do not use to pick up flammable.